Skip to Content

     Welcome to Source Robotics forum      


Sign up

This question has been flagged
7 Views

In case you assembled your robot and J1 sensor does not trigger you will need to
tighten J1 homing screw. It is located under J2 gearbox and to do that you will need
to use stubby allen key or sand down one end of allen key until it is able to fit in the hole.

Avatar
Discard

Your Answer

Please try to give a substantial answer. If you wanted to comment on the question or answer, just use the commenting tool. Please remember that you can always revise your answers - no need to answer the same question twice. Also, please don't forget to vote - it really helps to select the best questions and answers!

Related Posts Replies Views Activity
2
Mar 25
197
0
Feb 25
139
1
Jan 25
175
0
Apr 25
68
2
Apr 25
272